B) 1.5 Horse Power Single Phase 115 Volt Motor, Type TEFC.
C) Right Angle Gear Reducer.
D) Foot Switch with 7.5 feet of cord connected to motor and 9 feet of cord for connection to power supply.
E) 2 Chain Sprockets, Roller Chain and Adjustable Base to tighten chain.
F) Chain Guard.
G) Steel base plate to which both the reduction gear housing and the swaging machine can be secured in their proper relative locations by cap screws.
Unless otherwise specified in the customer’s purchase order, power drive units will be shipped from the factory wired for 115 volts power supply and the 9 ft. 3-wire power supply cable will have a standard 3-prong plug (2 line and 1 ground) assembled to its free end.
可替换模具 - 另售
注意事项
在 1 x 19 结构的钢丝绳上安装接头时，请记住这种结构的钢丝绳几乎没有压缩力。钢丝绳本身非常坚固，几乎没有 "松动"。
Before installing a set of roll dies, wipe their actives surfaces carefully with a clean soft cloth to be sure not grit will mar the surfaces of the roll dies.
工厂安装： 如果订购，动力驱动装置将在出厂时装配到 II 型弯管机上。
在这种情况下，II 型锻造机和动力驱动装置的组件连接并封闭在装运容器/工作台的下半部分，模具和附件固定在上半部分。同样，在客户工厂收货时，将 II 型锻造机和动力驱动装置的组件从装运箱/工作台上拆下，转移到工作台表面，并将装运螺栓插入工作台上的预钻孔中固定。
简体中文 
English 
Français 
Español de México 
Nederlands 
Deutsch 
Italiano